More Related Contents:
- why we can’t move a 64-bit immediate value to memory?
- Can I add 64bit constants to 64bit registers?
- what does “mov offset(%rip), %rax” do?
- What does an asterisk * before an address mean in x86-64 AT&T assembly?
- What is callq instruction?
- What’s difference between number with $ or without $ symbol in at&t assembly syntax?
- Why do x86-64 instructions on 32-bit registers zero the upper part of the full 64-bit register?
- Why doesn’t GCC use partial registers?
- Printing an integer as a string with AT&T syntax, with Linux system calls instead of printf
- CS:APP example uses idivq with two operands?
- MOVing between two memory addresses
- Why is (or isn’t?) SFENCE + LFENCE equivalent to MFENCE?
- Why can’t I move directly a byte to a 64 bit register?
- What is the meaning of MOV (%r11,%r12,1), %edx?
- Why use LDR over MOV (or vice versa) in ARM assembly?
- What was the original reason for the design of AT&T assembly syntax?
- Why does the x86-64 GCC function prologue allocate less stack than the local variables?
- Bomb lab phase_4
- x86_64 registers rax/eax/ax/al overwriting full register contents [duplicate]
- Does it make any sense to use the LFENCE instruction on x86/x86_64 processors?
- Questions about AT&T x86 Syntax design
- How to determine if the registers are loaded right to left or vice versa
- How to use RIP Relative Addressing in a 64-bit assembly program?
- Using 8-bit registers in x86-64 indexed addressing modes
- Why can I access lower dword/word/byte in a register but not higher?
- What’s the best way to remember the x86-64 System V arg register order?
- rsp doesn’t move when entering new function [duplicate]
- Why mov/cmp instead of cmp with two memory operands? [duplicate]
- Handling calls to (potentially) far away ahead-of-time compiled functions from JITed code
- Why use RIP-relative addressing in NASM?