More Related Contents:
- rbp not allowed as SIB base?
- How to read the Intel Opcode notation
- What does the /4 mean in FF /4?
- How to determine if ModR/M is needed through Opcodes?
- What does “rep; nop;” mean in x86 assembly? Is it the same as the “pause” instruction?
- Get size of assembly instructions
- x86 32 bit opcodes that differ in x86-x64 or entirely removed
- Why do x86-64 instructions on 32-bit registers zero the upper part of the full 64-bit register?
- What’s the purpose of the LEA instruction?
- Why doesn’t GCC use partial registers?
- Why are signed and unsigned multiplication different instructions on x86(-64)?
- What do the E and R prefixes stand for in the names of Intel 32-bit and 64-bit registers?
- Why is (or isn’t?) SFENCE + LFENCE equivalent to MFENCE?
- Why is imul used for multiplying unsigned numbers?
- What are the names of the new X86_64 processors registers?
- x86 XOR opcode differences
- Does it make any sense to use the LFENCE instruction on x86/x86_64 processors?
- Why not store function parameters in XMM vector registers?
- Segmentation fault when using DB (define byte) inside a function
- How to multiply a register by 37 using only 2 consecutive leal instructions in x86?
- How to tell the length of an x86 instruction?
- When should I use size directives in x86?
- How to force NASM to encode [1 + rax*2] as disp32 + index*2 instead of disp8 + base + index?
- Using 8-bit registers in x86-64 indexed addressing modes
- How to tell the length of an x86 instruction?
- Why can I access lower dword/word/byte in a register but not higher?
- Arithmetic identities and EFLAGS
- What is callq instruction?
- What is the compatible subset of Intel’s and AMD’s x86-64 implementations?
- How does the CPU know how many bytes it should read for the next instruction, considering instructions have different lengths?